User's Manual

Swing Door Sensor Installation Installing the Swing Door Sensor

12-6

MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION80-J7615-1

Rev. A

Swing Door Sensor Installation

1. Remove the taillight assembly from the trailer’s passenger side. Most taillight

assemblies are held into place by a large rubber grommet.

2. Using a center punch, mark a spot on the door post to line up with the horizontal line

and the middle of the door when the door is closed. This is where the switch will be

located.

3. Drill a 1/2" hole at this point in the door post.

4. Feed the 24" leads of the sensor through the 1/2" hole and out the bottom of the door

post into the area behind the taillight.

04AAA_206D

Mark at

door edge

Center line of

door width

Mark

Drill 1/2" diameter hole

DRAFT