User's Manual
System Verification and Final Steps Installing the TT210 Terminal on Reefers
8-14
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION80-J7615-1
Rev. A
2. Verify the lower cover seal is in place and not damaged.
figure showing back and gasket
???
3. Reinstall the lower cover being careful not to over-tighten.
need fig like 06aaa-60a
below?????????
4. If you are using a battery-powered drill, the drill should NOT be set on “Drill.” The drill
should be set on a low torque setting.
06AAA_60A
DRAFT