User's Manual

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 8-9
Installing the TT210 Terminal on Reefers Mount Installation
5. Excess cable can be coiled and stored in a safe place where it will not interfere with
other cables or components.
6. At the 7-way receptacle, make all power connections. If the 7-way receptacle has circuit
breakers, be sure to connect on the unprotected (truck) side of the circuit breakers.
a. Attach the 7.5 amp supplied fuse holder to the blue POWER wire on the T2 system
power/accessory cable using a butt splice.
b. Connect the other end of the fuse holder to pin 7 in the 7-way receptacle.
c. Connect the white GROUND wire to pin 1 in the 7-way receptacle.
Refer to TT210 Power/Accessory Cable Installation on page 10-4 for more information
pertaining to cable and wire connections.
Note
Use extreme caution not to route the cable where it could interfere with service cables,
components, or removable parts.
7. Where the cables enter the terminal, install the provided split grommet securely into the
cable hole. Ensure the grommet is fully seated.
8. Make Reefer connections depending on type of unit. See following sections.
06AAA_138A
GRN
RED
YEL
BLK
BLU
BRN
Blue (POWER) Pin 7
White (GND) Pin 1
TT210 Power/Accessory
Cable routed to the 7-way connector
DRAFT