User's Manual
80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 8-3
Installing the TT210 Terminal on Reefers Software
Software
Make sure you have the correct software for the appropriate reefer model.
Carrier Advance Controller units must have DataTrak software 04.03.00 or higher installed
and SATCOM configured to “Other.”
To check the software version, follow these steps.
1. Turn ON power.
2. Wait for self-test to finish.
3. Press SELECT until VIEW DATA displays.
4. Press the DOWN ARROW to view the data list items. Choose INSTALLED OPTIONS.
5. Press = (equal key) to view Options menu. Check that it shows DATATRAK
INSTALLED.
6. Perform the following procedure to check the SATCOM setting.
7. Turn OFF the reefer power switch.
8. Short Tx (B) and Rx (A) on the reefer configuration port. A connector (P/N 22-50180-00)
designed to short the A and B pins is available from your carrier dealer.)
SETPOINT
BOX TEMPERATURE
SELECTSELECT
START-STOP/START-STOP/
CONTINUOUSCONTINUOUS
MANUAL MANUAL
DEFROSTDEFROST
ALARM LISTALARM LIST
!
=
HEAT COOL
DEFROST
ALARM
START- STOP
CONTINUOUS
START / RUN
o
OFF
SETPOINT
BOX TEMPERATURE
SELECTSELECT
START-STOP/START-STOP/
CONTINUOUSCONTINUOUS
MANUAL MANUAL
DEFROSTDEFROST
ALARM LISTALARM LIST
!
=
HEAT COOL
DEFROST
ALARM
START- STOP
CONTINUOUS
START / RUN
o
OFF
DRAFT