User's Manual

Reefer Minimum Requirements Installing the TT210 Terminal on Reefers
8-2
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION80-J7615-1
Rev. A
Reefer Minimum Requirements
Tethered and Untethered System Comparison
Unlike the tethered system, the untethered system currently does not transfer reefer data to
the MCP unit in the tractor. However, it does send trailer ID so that connects and disconnects
can be detected by the MCP unit in the tractor.
If you are switching a reefer other than Carrier Standard from the tethered system to the
untethered system, the communications settings must be changed.
For Carrier Advance units, the Data Trak communications must be set to “Other”; for Thermo
King, the i-Box must be set to “Third Party.”
Note
The Thermo King and Carrier “Qualcomm” setting is for tethered system units only.
Cables
Make sure you have the correct cable for the appropriate reefer model.
Make/Model Cable
Minimum Hardware/
Firmware Communication Settings
Carrier Standard
(with data
logger)
45-J7854-6
(5-pin circular Deutsch
connector)
3.30 EEPROM N/A
Carrier Standard
(without data
logger)
45-J7856-6
(3-pin Packard
connector)
3.30 EEPROM N/A
Carrier Advance 45-J7856-6
(3-pin Packard
connector)
DataTrak software
installed
Other
Thermo King
(pre 2010 i-Box)
45-J7857-6
(6-pin circular Deutsch)
i-Box with
minimum 5308
software installed
Third-Party
(requires Thermo King
technician with service
tool)
Thermo King
(2010 or later
i-Box)
45-JB082-6
(6-pin rectangular
Deutsch, 2010 or later)
i-Box with
minimum 5308
software installed
Third-Party
(requires Thermo King
technician with service
tool)
DRAFT