User's Manual

Installation Installing the TT210 Terminal on Containers
7-6
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION80-J7615-1
Rev. A
NEED FIGURE> KEVIN TO GET JERRY DRAWING INFO...gromits etc.
7. Verify all mechanical and electrical components (cables, wires, optional sensors) are
properly connected.
8. Install the cargo sensor (follow directions in Chapter 11: Installing the Cargo Sensor)
9. Install the battery inside the terminal.
Clip the battery into place, use provided zip ties, connect the connector, and install the
battery cover with provided screws.
add zip ti
e
10. Close the terminal and make sure it is sealed.
a. Ensure gasket is properly seated. (figure)
b. Attach the unit cover.
11. Configure or pair the terminal to the proper container ID.
a. Wake up the terminal with the key fob.
Connector
Battery Pack
Battery Cover
10AAA_09A
DRAFT