User's Manual

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 6-7
Installing the TT210 Terminal on Plate Nose Trailers Installation
b. Connect the white GROUND wire to pin 1 in the 7-way receptacle using a ring
terminal.
If the 7-way receptacle has circuit breakers, be sure to connect on the unprotected
(truck) side of the circuit breakers.
10. Connect the circular connector to the terminal. This connector is “keyed” and will only
go on in one position. Do not use excessive force.
11. Verify all mechanical and electrical components (cables, wires, optional sensors) are
properly connected.
12. Install the optional cargo sensor if used (follow directions in Chapter 11: Installing the
Cargo Sensor).
13. Install optional door or auxiliary sensors if used (Chapter 12: Installing the Swing Door
Sensor, Chapter 13: Installing the Roll Door Sensor, Chapter 14: Installing the Auxiliary
Sensor).
14. Install the battery inside the terminal.
Place the battery into place, use provided zip ties, and attach the battery connector.
05AAA_217E
GRN
RED
YEL
BLK
BLU
BRN
Blue (PWR) Pin 7
White (GND) Pin 1
7.5 amp Fuse
DRAFT