Installation Guide

80-53184-1 Rev. A QUALCOMM Proprietary 11
Terrestrial Mobile Communications Terminal Installation Instructions Handset Installation
Handset Installation
Selecting a Location
The Handset includes a cradle that holds and protects the phone when not in use. The most common
installation location is on the dashboard, closer to the driver’s side of the cab. Consider the following
when choosing an exact installation location:
• The owner’s preference
• Whether there is a team or a single driver
• Whether there is enough clearance to easily lift the unit out of the cradle
Installing the Hand-set and Cradle
Follow these steps to install the Handset:
1.
Verify that there is nothing behind the mounting surface that might be damaged by the screws.
2.
Mount the cradle into position and install the screws. Be careful not to damage the cradle or
mounting surface by over-tightening the screws.
3. Place the phone into the cradle and route the cable back toward the TCU mount location.
TCU Installation
The TCU is installed in three basic steps:
1.
Selecting and marking an installation location
2.
Attaching the TCU to the cab wall
3.
Connecting all cables to the TCU