Installation Guide

80-53184-1 Rev. A QUALCOMM Proprietary 9
Terrestrial Mobile Communications Terminal Installation Instructions EDU and Holster Installation Procedures
2.
Remove the protective caps on the connectors only when you are ready to connect the cable to
the TCU and the display unit.
Connecting the EDU Cable to the EDU
Follow these steps to connect the EDU Cable to the EDU:
1.
To open the access door at the back of the EDU, press the two snaps that hold the door in place
and lift the door. Remove the bag of hardware.
2.
Route the cable through the appropriate channel on the back of the unit. The cable can be routed
so that it emerges from the right or left side of the unit. Usually it is routed so that the unit can be
pulled to the driver’s side without interference from the loose, coiled cable.
Straight
Bent
Protective cap
installed on connector