Installation Guide

EDU and Holster Installation Procedures Terrestrial Mobile Communications Terminal Installation Instructions
8 QUALCOMM Proprietary 80-53184-1 Rev. A
If you do not use the backing plate:
a. Verify that there is nothing behind the mounting surface that might be damaged by the
screws.
b. Install the screws. Be careful not to damage the holster or mounting surface by over-
tightening the screws.
If you do use the backing plate:
c. Verify that the rear of the mounting surface is accessible and that there is enough space for
the backing plate.
d. Using the holster as a guide, carefully drill the five 1/8" holes in the mounting surface.
e. Place the backing plate behind the mounting surface, and insert the screws through the
holster and into the plate.
f. Tighten the screws. Be careful not to damage the holster, mounting surface, or backing
plate by over-tightening them.
2.
Remove any protruding sharp ends of the Holster mounting screws that might cut into wiring or
other objects behind the mounting surface.
Inspecting Cables
Inspect the EDU Cable as follows:
1.
Inspect the EDU Cable connectors to make sure they are not damaged and the pins are not bent.
Do not attempt to straighten bent pins. This further weakens the pins and results in cable failure.
(See the following illustration.)
50-2758-1
Holster
mounting
screw
Mounting
surface
Holster 10-8570-1
for
Enhanced Display
Unit
(EDU) 10-8575-1
Backing Plate
50-2758-1
(optional)