Installation Guide

TCU Antennae Installation Terrestrial Mobile Communications Terminal Installation Instructions
6 QUALCOMM Proprietary 80-53184-1 Rev. A
GPS Antenna Mounting Procedures
1.
After orienting the antenna, drilling the 1-inch diameter hole, and cleaning the surface with
alcohol, remove the liner from the bottom of the antenna.
2.
Route the cable through the mounting hole.
3.
Position the GPS antenna over the mounting hole and adhere. Ensure that the adhesive mates to
the top surface.
4.
Attach the provided clip retainer over the exposed antenna base.
PCS Antenna Mounting Procedures
1.
After orienting the antenna, drilling the .748-inch diameter hole, and cleaning the surface with
alcohol, insert the antenna base from the inside of the tractor roof. Make sure the base is properly
centered in the hole.
2.
Make sure that the rubber seal is in the groove of the nut.
3.
Tighten the nut 3-35 Nm with the supplied wrench.
4.
Attach the PCS radiator, whip antenna.
99AAB_02
Truck cab roof
PCS Antenna
GPS
Antenna
PCS ground
plane
GPS
clip
Drilled holes