User Manual
Table Of Contents
- SWOC-T Integrator’s Manual
- Contents
- 1 Introduction
- 2 Applicable Module
- 3 Available Global Modular Approvals
- 4 Additional Regulatory Conformance Testing and/or Submissions Required by the Integrator
- 5 Compliant and Allowable Tx Power Settings Programmed into EEPROM
- 6 Allowable Antennas to Use with the Radio Module
- 7 Label Information
- 8 Required Regulatory Wording for User Manual and Installation Manual
SWOC-T Integrator’s Manual Required Regulatory Wording for User Manual and Installation Manual
80-P8867-5 Rev. B Confidential and Proprietary – Qualcomm Technologies, Inc. 12
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
The user may find the following booklet prepared by the Federal Communications Commission
helpful:
Interference handbook
This booklet is available from the U.S. Government Printing Office, Washington, D.C. 20402.
Stock No.004-000-00345-4.
RF exposure statement
The products comply with the FCC mobile RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation with 20 cm separation distance.
8.2 Industry Canada notice
This device complies with Canadian RSS-210.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the
device.
Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils radio
exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif
ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage
reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable.
RF exposure statement
This device is approved under mobile category with 20 cm separation distance.
Cet appareil est homologué en catégorie mobile avec une distance de séparation de 20 cm.
8.3 European Community (R&TTE) user manual wording
and declaration
NOTE: Text in red font must be replaced with the name of the company responsible for placing the
system on the European Community Market.
Europe – EU Declaration of Conformity
Marking by the above symbol indicates compliance with the Essential Requirements of the
R&TTE Directive of the European Union (1999/5/EC). This equipment meets the following
conformance standards:
EN300 328, EN 301 893, EN 301 489-17, EN60950, EN 62311