User Manual
Table Of Contents
- SWOC-T Integrator’s Manual
- Contents
- 1 Introduction
- 2 Applicable Module
- 3 Available Global Modular Approvals
- 4 Additional Regulatory Conformance Testing and/or Submissions Required by the Integrator
- 5 Compliant and Allowable Tx Power Settings Programmed into EEPROM
- 6 Allowable Antennas to Use with the Radio Module
- 7 Label Information
- 8 Required Regulatory Wording for User Manual and Installation Manual
80-P8867-5 Rev. B Confidential and Proprietary – Qualcomm Technologies, Inc. 11
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
8 Required Regulatory Wording for User
Manual and Installation Manual
The integrator must include text in the user manual to meet the regulator’s requirements. The
following text or similar wording should be used.
NOTE: The text in red font must be replaced.
8.1 FCC compliance information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This product does not contain any user serviceable components. Any unauthorized product
changes or modifications will invalidate warranty and all applicable regulatory certifications and
approvals, including authority to operate this device.
FCC Part 15 Digital Emissions Compliance
We [System Manufacturer Name, Address, Telephone], declare under our sole responsibility
that the product [System Name] complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired
operation.
WARNING: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates and radiates radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
■ Reorient or relocate the receiving antenna
■ Increase the separation between the equipment and receiver
■ Connect the equipment into an outlet on a circuit different from the one the receiver is
connected to
■ Consult the dealer or an experienced radio/TV technician for help