User's Manual

Setting Up the QDBS–Broadband
– 39 –
QUALCOMM Confidential and Proprietary
MAY CONTAIN U.S. EXPORT CONTROLLED INFORMATION
80-D9001-1 Rev. A
1
2
3
4
5
do so may result in the antenna detaching from the mounting surface and seriously
injuring personnel.
To connect a macro-cell antenna:
1.
Connect the two macro-cell antennas (Transmit and Receive) to the desired mounting
structure.
NOTE: The two antennas should be at least five (5) feet apart for receive signal
diversity.
6
7
8
9
10
11
12
2.
Connect one end of the ½ inch diameter RF coax cable to bottom of the Transmit
antenna.
3.
Repeat Step 2 for the Receive Antenna.
4.
Connect the Transmit Antenna cable to the port labeled TxRx 0 of the Radio Case
CIP.
NOTE - Do not attach the RF load to the transmit port when a macro-cell antenna is
attached, as the system range will be greatly reduced.
13
14
15
5.
Connect the Receive Antenna cable to the port labeled Rx 1 of the Radio Case CIP.