User's Manual

Unpacking and Inspecting QDBS Release 3.0 Hardware
- 22 -
QUALCOMM Confidential and Proprietary
MAY CONTAIN U.S. EXPORT CONTROLLED INFORMATION
80-D9001-1 Rev. A
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
3.2. Unpacking the QDBS–Broadband
The QDBS–Broadband is shipped in two large cardboard boxes. The QDBS–Broadband and
shipping materials weigh approximately 350 pounds and can be lifted using a pallet jack or fork lift.
To unpack the QDBS–Broadband:
1.
Cut the shrink wrap from around the boxes on the pallet and discard.
2.
Remove the tops of the telescoping cardboard boxes and store in a safe place.
3.
Remove any packing material and corner pads from the top or sides of the transit
cases.
Save all packing material in the event the equipment needs to be returned for servicing.
4.
Remove each transit case from the lower portion of the cardboard box.
3.3. Inspecting equipment and cable connections
Before using the QDBS–Broadband, remove the transit case covers (see Setting up the transit cases on
page 35 for more details), and perform a thorough inspection of the equipment to ensure there is no
loose or damaged hardware. Verify that power and signal cables are not cut, chafed, or worn. Also
verify that all AC power and signal cables are fully seated in their designated receptacles and ports. If
there is any visual damage to the equipment, contact the QUALCOMM Sales Administration team
toll free at 800.777.9070, or 858.651.1016.
3.3.1. Equipment list
The following is a list of the ancillary equipment that is included with the COTS QDBS–Broadband.
Table 1: Ancillary equipment
Equipment Quantity Description
GPS Antenna Kit 1
Optional if in overlay
scenario.