User's Manual

- 21 -
QUALCOMM Confidential and Proprietary
MAY CONTAIN U.S. EXPORT CONTROLLED INFORMATION
80-D9001-1 Rev. A
1
2
3
4
5
6
7
8
9
10
Section 3
Unpacking and
Inspecting QDBS–
Broadband Hardware
The QDBS–Broadband is shipped with all the electronic components fully assembled in the Radio
and Network Cases.
3.1. Required tools
3.1.1. Pico-cell mode assembly
The GPS antenna stand must be assembled; however, tools are not required to set up the QDBS–
Broadband in pico-cell mode (without an antenna mast or external antennas).
3.1.2. Macro-cell mode assembly
To operate the QDBS–Broadband in macro-cell mode (with external antennas), some standard tools
such as wrenches, screw drivers, and pliers, are required to set up the antennas. These standard tools
are not supplied with the QDBS–Broadband.