User's Manual


Turning Your Phone On and Off
11
Turning Your Phone On and Off
Because of the secure features of your phone, it takes approximately 45 seconds to power
on your phone.
To Turn Your Phone On
1
Press the Power/End-call ( ) key.
The QSec-2700 logo is displayed and the secure LED is lit.
The phone cycles through a series of displays:
"
Software verification in progress
"
Software successfully authenticated
1
Check the icons on the Home screen to see if you are receiving a signal (see
“Screen Icons” on page 9). The Home screen includes the banner, date and time.
To Turn Your Phone Off
1
Press and hold the Power/End-call ( ) key for one to three seconds.
The following notifications are displayed on the screen:
"
"Continue holding the END key to power down"
"
After three seconds, "Powering down", immediately followed by “Secure
powering down” and the QSec-2700 logo. The secure LED is lit.
Note
If the self-test fails, try turning your phone on again. See “Troubleshooting” on
page 123 for possible solutions. Contact your Terminal Administrator for
assistance if this condition persists.