User Instructions
Table Of Contents
- 1 Introduction
- 2 Applicable Module
- 3 Available Global Modular Approvals from Qualcomm Technologies, Inc.
- 4 Additional Regulatory Conformance Testing and/or Submissions Required by the Integrator
- 5 Compliant/Allowable Transmit Power
- 6 Allowable Antennas to Use with the Radio Module
- 7 Antenna Placement Inside the Host System and RF Safety
- 8 Simultaneous Transmission with Other Integrated or Plug-In Radios
- 9 Module May Not Be Installed by End Users
- 10 Required Labeling on the Outside of the Host
- 11 Required Labeling on the Module
- 12 Required Regulatory Wording for User Manual/Installation Manual
- 13 OEM Integrator Checklist
80-KA570-12 Rev. B MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 18
12 Required Regulatory Wording for User
Manual/Installation Manual
The integrator must include text in the user manual meeting the regulators’ requirements. The text
below or similar wording should be used.
NOTE: Text in red must be replaced.
12.1 FCC compliance information
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
This product does not contain any user serviceable components. Any unauthorized product
changes or modifications will invalidate the warranty and all applicable regulatory certifications
and approvals, including authority to operate this device.
FCC Part 15 Digital Emissions Compliance
We [System Manufacturer Name, Address, Telephone], declare under our sole responsibility
that the product [System Name] complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates and radiates
radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: