User Instructions
Table Of Contents
- 1 Introduction
- 2 Applicable Module
- 3 Available Global Modular Approvals from Qualcomm Technologies, Inc.
- 4 Additional Regulatory Conformance Testing and/or Submissions Required by the Integrator
- 5 Compliant/Allowable Transmit Power
- 6 Allowable Antennas to Use with the Radio Module
- 7 Antenna Placement Inside the Host System and RF Safety
- 8 Simultaneous Transmission with Other Integrated or Plug-In Radios
- 9 Module May Not Be Installed by End Users
- 10 Required Labeling on the Outside of the Host
- 11 Required Labeling on the Module
- 12 Required Regulatory Wording for User Manual/Installation Manual
- 13 OEM Integrator Checklist
80-KA570-12 Rev. B MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 17
11 Required Labeling on the Module
11.1 FCC labeling on the Module
The integrator must ensure that the FCC ID (as indicated in Chapter 1)) is affixed on the Module
along with other country certification numbers and logos as described herein.
NOTE: The Module original design manufacturer (ODM) may affix regulatory labeling at the time of
Module manufacturing. However, the production contract original equipment manufacturer
(PCOEM) must ensure the Module label is complete, correct, and applicable for all countries to
which the host system is to be imported, marketed, or sold.
11.2 Rest of world labeling on the Module
The integrator must ensure the Module includes a global regulatory label with certification
numbers and logos for all target countries. The system integrator is responsible to confirm that the
final regulatory label on the radio Module contains all required certification IDs for all countries
in which the system will be marketed or sold.
It is recommended that the PCOEM implement a review and sign-off process as well as change
control process with each Module ODM to ensure that the module label meets PCOEM
requirements.
QTI provides sample artwork with the applicable certification numbers for this Module. The
provided PDF document can be opened using Adobe Illustrator, so the sample artwork can be
copied and modified as needed. Therefore, the final label produced by the Module manufacturer
will vary from this sample. However, the logos and certification numbers must be those shown in
the sample global label.
Contact your QTI account representative with any questions regarding module labeling.
11.3 Instructions to download the sample global label
artwork with certification IDs
1. Log in to the QTI CreatePoint system. Follow the links to regulatory certifications.
NOTE: Search for Module QM8626 in the CreatePoint system.
2. Find Sample Labeling for Module.
3. Download the PDF file found in the folder.
If you do not have access to the CreatePoint system, contact your QTI account representative
to request the Sample Label file.