User Instructions
Table Of Contents
- 1 Introduction
- 2 Applicable Module
- 3 Available Global Modular Approvals from Qualcomm Technologies, Inc.
- 4 Additional Regulatory Conformance Testing and/or Submissions Required by the Integrator
- 5 Compliant/Allowable Transmit Power
- 6 Allowable Antennas to Use with the Radio Module
- 7 Antenna Placement Inside the Host System and RF Safety
- 8 Simultaneous Transmission with Other Integrated or Plug-In Radios
- 9 Module May Not Be Installed by End Users
- 10 Required Labeling on the Outside of the Host
- 11 Required Labeling on the Module
- 12 Required Regulatory Wording for User Manual/Installation Manual
- 13 OEM Integrator Checklist
80-KA570-12 Rev. B MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 15
10 Required Labeling on the Outside of the
Host
NOTE: Explanatory text in red must not be included in the final label.
10.1 FCC
The FCC requires a label on the outside of the host system visible to the end user.
Example wording is as follows:
Contains:
FCC ID: XXX-XXXXXXX
IC: XXXXX-XXXXXX
(Replace X’s with actual IDs found in Chapter 1)).
The FCC requires a logo signifying emissions compliance on the outside of the host system.
Additional options are available for placement of the FCC label on the host. Refer to the FCC
Knowledge Database KDB784748.
NOTE: The Integrator is responsible for performing FCC Part 15 Class B digital emissions testing on the
end system with the radio Module installed. The FCC logo below should not be affixed unless the
OEM integrator has obtained the necessary Part 15 approval, e.g., Self-Declaration of
Conformity.
If the host system is approved to FCC Class B digital emissions limits under a grant of
certification issued by a TCB, the FCC ID number shown on the grant should be used on the label
instead of the FCC logo below.
10.2 European Community R&TTE
The European Community R&TTE Directive requires the CE marking shown below on the
outside of the host AND on the outside of the shipping container/packaging: