User's Manual

Connecting Accessories 25
Connecting the external BBPS to the NIU
Connecting the panel antenna to the NIU
NOTE
To assemble the BBPS, refer to
the directions in the BBPS
package.
1. Attach the BBPS connector
to the NIU.
2. Attach the power cord to the
BBPS.
3. Plug the power cord into the
wall outlet.
4. If desired, replace the
connector cover.
1. Attach one end of the coaxial
cable to the panel antenna.
2. Attach the other end of the
coaxial cable to the NIU.
3. Connect AC adaptor to the NIU.
4. Plug AC adaptor into wall outlet.
NOTE
QUALCOMM recommends use of high-
quality coaxial cable to avoid
degrading signal strength. Check local
regulations to determine if a
minimum cable loss is required. For
operation within the U.S., the
minimum cable loss shall be 3 dB.
Locate the NIU such that its antenna
remains at least 20 cm (8 inches)
from user.
To test for signal strength, see
page 19.
3
2
1
3
4
1
2