User's Manual
Table Of Contents
Quick Start: Connecting Unit
iii
QUICK START: CONNECTING UNIT
➀
Connect your phone to
the Network Interface
Unit (NIU).
a. Slide connector panel cover (see
illustration on page 3) off back
of NIU.
b. Plug telephone connector into
one of the telephone jacks on
the NIU. Be sure the phone is set
for touchtone dialing (see
page 6).
c. Plug the other end of the
connector into your touchtone
telephone.
➁
Connect the antenna.
a. Align the nut on the antenna
with the thread on the NIU.
b. Thread the antenna onto the
NIU’s antenna connector and
hand-tighten.
c. Position the antenna vertically
for optimal reception.
➂
Attach the power source.
a. Insert the small plug on the AC
adaptor into the DC jack on the
back of the NIU.
b. Plug the AC adaptor into any
available AC wall outlet
providing the voltage specified
on the adaptor.
c. Reattach connector panel cover
if desired (see illustration on
page 3).
3
1
2
Make a call
1. Lift the handset.
2. Listen for a dial tone.
(If dial tone is not
present, see the
“Troubleshooting”
section.)
3. Press the appropriate
digit keys to dial the
desired phone number.
4. Replace the handset in
the cradle to end the
call.