User Guide

46 pdQ Basics Handbook
QUALCOMM Proprietary 80-68788-1 Rev X2, PRELIMINARY - 10/26/98
Using Menus
Graffiti Menu Commands
Most menu commands have Graffiti “Command stroke” equivalents — similar
to keyboard commands on computers. The command letters appear on the
right side of the menu commands.
To use the Graffiti menu commands, draw the Command stroke followed by
the corresponding command letter. When you draw the Command stroke, the
Command symbol appears just above the Graffiti writing area to indicate
that you are in Command mode.
For example, to activate the Select All command in the previous diagram,
draw the Command stroke, followed by the letter “s.”
You do not have to tap or access the menus when you use the
Graffiti menu commands. However, since the Command mode is
active for approximately two seconds, you must write the letter
character immediately to activate the menu command.
Edit Menu Commands
The Edit menu is available with any screen where you enter or edit text. In
general, the Edit Menu commands available in the Edit menu apply to text
that you select in an application.
To select text in an application:
1 Tap the beginning of the text that you want to select.
2 Drag the stylus over the text to highlight it (in black).
You can drag across the text to select additional words, or drag
down to select a group of lines.
Command
Command letters
Menu commands
pdQ basic.book Page 46 Monday, October 26, 1998 8:46 AM