User's Manual

80-J4866-1 Rev. A 1/9/06 7-3
ALL INFORMATION SUBJECT TO CHANGE
Remote Control Device (RCD) Installation Installing the Remote Control Device (RCD)
DR
A
FT
D
O
N
OT
C
OP
Y
Installing the Remote Control Device (RCD)
1. Prepare the mounting surface for installation.
Use the alcohol wipes provided to clean the mounting surface of any dirt or grime.
2. Adhere the 3 strips of VHB tape provided to the back of the RCD.
3. Affix the RCD to the dash panel.
Be sure you have chosen a suitable location for the RCD, as the VHB (very high bond)
tape
permanently
bonds the device to the dash panel.
Connecting to the Accessory Cable
Once the accessory cable is installed and connected to the RCD as described in Chapter 9,
butt splice the RCD wires to the accessory cable wires as follows:
butt splice one RCD wire to the blue/green RCD wire on the accessory cable,
butt splice one RCD wire connects to the violet COM5 GND wire on the accessory cable.
The COM5 GND wire is also used for the speaker cable ground.
05AAA_219A
BACK
O
P
T