User's Manual

Inspecting the Display Unit Cable Display Unit Installation
6-6 1/9/06 80-J4866-1 Rev. A
ALL INFORMATION SUBJECT TO CHANGE
D
RAF
T
DO NOT
CO
PY
Inspecting the Display Unit Cable
1. Remove the protective cap on the connector only when you are ready to connect the
display unit cable to the MAS and MDU.
2. Inspect the display unit cable connectors to make sure they are not damaged and the
pins are not bent. Do not attempt to straighten bent pins. This further weakens the pins
and results in cable failure.
The following illustration shows good (straight) cable connector pins and damaged
(bent) cable connector pins.
Return a display unit cable with bent pins according to the Return Material Authorization
Material (RMA) procedure in Appendix C.
05AAA_042
Straight
Bent
OM/E-0093-50