User's Manual

80-J4866-1 Rev. A 1/9/06 5-3
ALL INFORMATION SUBJECT TO CHANGE
Satellite Data Modem (SDM) Installation Connecting the SDM Cable
DR
A
FT
D
O
N
OT
C
OP
Y
Connecting the SDM Cable
To install the SDM cable on the SDM cable connector, hand-tighten the connector.
Caution
If the cable does not easily connect to the SDM cable connector, check the part
number of the cable to make sure you are using the SDM cable.
WARNING
The SDM connector is already weather-resistant; do not attempt to weather-proof the SDM
connector.
General Installation Guidelines
Provide adequate clearance from any nearby structures such as airdams and exhaust
stacks.
When you install an exposed SDM mount, position it on the driver’s side, if possible, where
tree branches and other hazards will less likely contact the SDM.
DO NOT install SDMs on headache racks or exhaust pipes.
Caution
Headache racks are mounted to the vehicle frame and there is no shock
cushioning. An SDM mounted on a headache rack risks damage. QUALCOMM
reserves the right to charge for replacement or repair of damaged or malfunctioning
SDMs which QUALCOMM determines to have failed as a result of installation on
the headache rack.
DO NOT paint the SDM. Painting the SDM will degrade the performance of the MCP and void
the unit warranty. The SDM
mount may be painted, however.
DO NOT open the SDM. Removing the radome will void the warranty unless you have
obtained authorization and instructions from QUALCOMM. Removing the radome exposes
the MCP antenna to moisture.
DO NOT use power tools to tighten the SDM mount bolts. However, pneumatic tools can be
used.