User's Manual

80-J4866-1 Rev. A 1/9/06 4-11
ALL INFORMATION SUBJECT TO CHANGE
Installation Planning Tools and Supplies
DR
A
FT
D
O
N
OT
C
OP
Y
Tools and Supplies
The following tools and supplies are recommended for performing installations. Those
marked with a bullet (•) are considered the essential tools and supplies required to perform
an installation. Tools other than these may be required to facilitate certain installations and
maintenance.
Table 3-1. Tools and Supplies
Wrenches Misc. Tools
• Standard Combination Wrench Set • Diagonal Wire Cutters
Adjustable Wrench • Wire Strippers
• 3/16” Hex (Allen) Wrench • Butt Splice Crimping Tool
Rachet/Sockets • Level
• 3/8” Drive Standard Deep Well Socket Set Vise Grips
1/4” Drive Standard Deep Well Socket Set • Volt/ohm Meter
1/4” Rachet Hacksaw
3/8” Rachet Hammer
3/8” Drive Socket Set Utility Knife
9/16” Deep Socket Files (flat, round)
Screwdrivers Channel Locks
• Phillips #2 Straight Awl
Power Screwdriver (speeds installation time) Measuring Tape
Slotted
Torx Bit Set Misc. Supplies
Drill Bits • Silicone Sealant
• 3/8” Bit • Assorted Ring Terminals
• 5/16” Bit • Red, Blue, & Yellow Butt Splices
5/8” Bit and 3/4” Bit (both are available on 1/4-3/4 step/index drill
bit)
• Electrical Tape
• 7/8” Hole Saw Flash/Drop Light
• 1-1/4” Hole Saw Power Tools
Air Tools 14” Chop Saw (or tool capable of cutting
stock aluminum channel)
• 3/8” Drill Cordless Drill
3/8” Rachet