User's Manual

Cabover Engine (All Makes) Vehicle Types Installation Planning
4-10 1/9/06 80-J4866-1 Rev. A
ALL INFORMATION SUBJECT TO CHANGE
D
RAF
T
DO NOT
CO
PY
- Install so a 1 1/2" hole can be cut for the SDM cable.
Special Cable Ordering Instructions for Tilt Cabs
For tilt cabs (illustrated below), typically at least one cable must be routed through the cab
pivot point to allow for the tilt. In most tilt cab vehicles, this routing requires a longer cable
instead of the standard cable. When you order the MCP, specify the length of the cable(s) you
need.
(3) Tilt Cab
(4) Tilt Cab + Fixed Sleeper
Pivot Point
Pivot Point
Display
Unit
Outdoor
Unit
Power Bus/
Key
Switch
Comm
Unit
Comm
Unit
Comm Unit
Longer
Cable
Longer
Cables
Display
Unit
Power Bus/
Key
Switch
Outdoor
Unit