User's Manual

80-J4866-1 Rev. A 1/9/06 4-9
ALL INFORMATION SUBJECT TO CHANGE
Installation Planning Cabover Engine (All Makes) Vehicle Types
DR
A
FT
D
O
N
OT
C
OP
Y
Day Cab (All Makes) Vehicle Types
The following section illustrates the top-down view of typical installation locations for the
MAS, display unit, and cables in the day cab vehicle. Descriptions of the locations and the
reasons for selecting them are also provided.
•MAS
— Install where space allows.
- Install so there is always access to the SD card slot.
• Display unit
— Install where space allows and according to customer preference.
• Cables
— Route internally.
- Install so a 1 1/2" hole can be cut for the SDM cable.
Straight Truck Vehicle Types
The following section illustrates the top-down view of typical installation locations for the
MAS, display unit, and cables in the straight truck vehicle. Descriptions of the locations and
the reasons for selecting them are also provided.
•MAS
— Install in cab or sleeper where space allows. Attach to floor or bunk.
- Install so there is always access to the SD card slot.
• Display unit
— Install where space allows and according to customer preference.
• Cables
— Route externally or internally as appropriate. Tilt cabs will probably require longer
cables as noted below.
Day Cab (All Makes)
Display
Power Bus/
Key Switch
Comm Unit
Straight Trucks
(1) Fixed Cab
(2) Fixed Cab + Sleeper
Outdoor
Unit
Outdoor
Unit
Display
Unit
Display
Unit
Comm Unit
Power Bus/
Key Switch
Power Bus/
Key Switch
Comm Unit
Otd