User's Manual
Cabover Engine (All Makes) Vehicle Types Installation Planning
4-8 1/9/06 80-J4866-1 Rev. A
ALL INFORMATION SUBJECT TO CHANGE
D
RAF
T
DO NOT
CO
PY
Mack
•MAS
—
Install in the passenger side toolbox. Hang from the bunk.
- Install so there is always access to the SD card slot.
• Display unit
—
Install on the face of the connector panel where it will be accessible to both
the driver and passenger.
• Cables
—
Route externally.
- Install so a 1 1/2" hole can be cut for the SDM cable.
Cabover Engine (All Makes) Vehicle Types
The following section illustrates the top-down view of typical installation locations for the
MAS, display unit, and cables in the cabover vehicle. Descriptions of the locations and the
reasons for selecting them are also provided.
•MAS
—
Install in the driver side toolbox. Hang from the bunk in a position so that, when the
cab is tilted, nothing will fall on the unit. This location allows for direct interior cable routing.
- Install so there is always access to the SD card slot.
• Display unit
—
Install on the dash where it will be accessible.
• Cables
—
Route internally. Because of easy access, connect the power cable to the main
bus or keyswitch.
- Install so a 1 1/2" hole can be cut for the SDM cable.
Display
Power-
Main
Power Bus
Antenna cable
access hole
Comm
Unit
Mack
OM/E0093 10E
Comm
Unit
Antenna cable
access hole
Display
Electrical
Panel
Cabover Engine