User's Manual

80-J4866-1 Rev. A 1/9/06 4-5
ALL INFORMATION SUBJECT TO CHANGE
Installation Planning Conventional Vehicle Types
DR
A
FT
D
O
N
OT
C
OP
Y
Conventional Vehicle Types
The following section illustrates top-down views of typical installation locations for the MAS,
display unit, and cables in the conventional vehicle. Descriptions of the locations and the
reasons for selecting them are also provided.
International/Navistar
•MAS — Install in the driver side toolbox. Hang from under the bunk.
- Install so there is always access to the SD card slot.
• Display unit
— Install where space allows and according to customer preference.
• Cables
— Route externally or internally as appropriate.
- Install so a 1 1/2" hole can be cut for the SDM cable.
Freightliner FLD
•MAS — Attach to the floor in the small, less-used storage area on the passenger side under
the bunk. There is a pre-existing access hole here to the exterior. This compartment may
be accessed by lifting up the bunk.
- Install so there is always access to the SD card slot.
• Display unit
— Attach to the electrical access panel behind the gearshift lever where it is
accessible.
• Cables
— Route externally. Power cable connections are made at the A pillar at the driver-
side mirror.
- Cables exit/enter the sleeper near the MAS.
- Cables enter/exit the cab low on the passenger side of the firewall, away from the foot
area.
Power-
Main
Power Bus
Comm
Unit
International/Navistar
Key
Switch
Display
Electrical
Panel
Antenna cable
access hole
Comm
Unit
Freightliner
Existing
heater
box
A pillar
B pillar