User's Manual

Completing the Wire Connection Wiring Guidelines
3-6 1/9/06 80-J4866-1 Rev. A
ALL INFORMATION SUBJECT TO CHANGE
D
RAF
T
DO NOT
CO
PY
4. Do a pull test. Pull on both ends of the wires to ensure a solid butt-spliced connection
exists. The crimped butt splice securely grips the insulated wires.
Caution
If using heat shrinkable crimps, DO NOT use a heat gun or open flame near
combustible materials. Use a heat gun
only when it is safe and appropriate to do so.
Protect surrounding wiring and other components when using a heat gun.
Completing the Wire Connection
Create extra protection for the wire connection by following these additional steps:
1. Wrap a wire around four fingers of a hand, one full loop, so the wire loop is longer than
the butt splice.
2. Cinch tight the loop and center it against the butt splice.
03AAA_282
04AAA_45