User's Manual
Flowchart for Basic MCP System Verification Basic System Verification
10-10 1/9/06 80-J4866-1 Rev. A
ALL INFORMATION SUBJECT TO CHANGE
D
RAF
T
DO NOT
CO
PY
Flowchart for Basic MCP System Verification
It is important that you read the procedure following the flowchart, as it contains detailed
information to verify proper MCP system operation.
Check if screen
lights up,
displays
characters
No
Step 3
Turn ignition
ON
Step 2
Yes
See
Chapter 7
in this guide
Step 7
Check
brightness,
contrast, and
volume controls
Step 4
OK
Not OK
Replace
MDU
Display MCP
Status screen,
check status
Step 5
Check
NO SIGNAL
light
Step 6
See appropriate
chapter
in this guide
Status: ####
Status: GOOD
Still on
(after 10 minutes)
See
Chapter 5
in this guide
Off
(within 10 minutes)
Move unit
as needed to
see satellite
Step 1
Step 8
Step 10
Step 9
Display MCP
Diagnostic
screen
Verify battery
back up
voltage
OK
Display
Positioning
screen
Check
FC/no and
RC/no values
OK
Not OK
See
Chapter 16
in this guide
Not OK
See
Chapter 10
in this guide
Step 11
Yes
Verify
Data Base
Sync Complete
Go to Step 13
Step 12
Check status
GPS = GOOD
See
Chapter 11
in this guide
No