User's Manual

80-J4866-1 Rev. A 1/9/06 10-9
ALL INFORMATION SUBJECT TO CHANGE
Basic System Verification Option Screens
DR
A
FT
D
O
N
OT
C
OP
Y
External MPG Display Screen
The External MPG Display screen is used to test the MPG Display (if installed). For additional
information, see Chapter 17: MPG Display Installation in this guide.
• To test the MPG Display, press the CONTROL PANEL key to display the External MPG
Display screen and then press ▼ or ▲ until the MPG Display screen appears.
• To test the communication link between the MCP and the MPG Display, type the letter T.
This causes the word TEST to appear momentarily on the MPG Display screen.
• You can adjust the contrast using the display screen by typing a number between 1 and 4
and pressing ENTER. (Typing 1 will give the least contrast. Typing 4 will give the most
contrast.)
OMNI2 CONTROL PANEL
EXTERNAL MPG DISPLAY
_________________________________________________________
Press '1', '2', '3', or '4' to set
desired contrast level (4 = highest).
To test external display, press 'T'
and 'TEST OK' should appear on the
MPG DISPLAY.
USE
↑
(
(↓)
FOR MORE CONTROLS