User's Manual

80-J4866-1 Rev. A 1/9/06 9-15
ALL INFORMATION SUBJECT TO CHANGE
Cable Installation Connecting to an Existing Speaker
DR
A
FT
D
O
N
OT
C
OP
Y
Connecting to an Existing Speaker
1. Locate the speaker wires on the speaker, labelled “speaker + and speaker -.”
2. Cut the wires in a good location.
3. Butt splice the speaker cable leads, labelled “speaker,” to the loose ends leading
toward the speaker.
4. Butt splice the speaker cable leads, labelled “audio amp,” to the loose ends leading
toward the audio.
5. Butt splice 2 of the speaker cable leads, labelled “MAS,” to the accessory cable speaker
cable leads, labelled “speaker + and speaker -.”
6. Butt splice the remaining white speaker cable lead to the comm 3 ground.
Connecting to an External Speaker
1. Wire the added speaker directly to the accessory cable leads, labelled “speaker + and
speaker -.”
To MAS
To
Speaker
To
Audio
05AAA_232