User's Manual

Installing the Remote Control Device (RCD) Cable Cable Installation

9-14 1/9/06 80-J4866-1 Rev. A

ALL INFORMATION SUBJECT TO CHANGE

RAF

DO NOT

Installing the Remote Control Device (RCD) Cable

The 2 RCD cable wires connect to the accessory cable as follows:

• one wire connects to the blue/green RCD wire on the accessory cable

• one wire connects to the violet COM5 GND wire on the accessory cable

For specific information on the RCD cable, see Chapter 7: Remote Control Device (RCD)

Installation.

Installing the Speaker Cable

Choosing a Speaker

Text-to-speech works with either an existing speaker or a speaker that has been added.

• If you are using an existing speaker, the normal audio of the speaker will be overridden by

the OmniVision system whenever a message is played. This is handled by the built-in

relay on the speaker cable.

• If you are adding a speaker in order to have a dedicated speaker for the OmniVision

system, the speaker can be directly wired to the accessory cable. In this case, the speaker

cable is not used.

05AAA_219A

BACK