User's Manual

80-P7567-4 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 7
Figure 2.1 MTP9900 LAA external ports
2.3 LEDs
The MTP9900 LAA includes 4 LEDs on the front lower right side of the box, and two on the
front side of the box toward the bottom.
Table 2-1 MTP9900 LAA LEDs
Label Color Function
User1 Red Function defined by OEM/ODM
User2 Green Function defined by OEM/ODM
PWR Green When lit, power to the subsystem is good
12V Blue When lit, main input power (12v) is good
Link 3 Green When lit and/or flashing, GBE port #3 out of the GBE switch has link and is active
Link 2 Green When lit and/or flashing, Ethernet port #1 out of the GBE switch has link and is active
2.4 Antenna port SMA connectors
RF card connector port mapping and band switching information is provided in this section.
Figure 2.2 accompanies Table 2-2 to depict the antenna connector SMA locations and their
functionality.
NOTE: When attaching antennas or cables on SMA connectors, apply a torque value no greater than
8 in-lbs or 90 N-cm.