User's Manual

80-P7567-4 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 13
model referenced in the previous section. The antenna must be installed with a downward tilt
angle of at least 30 degrees.
■ FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
4.3 Radiation exposure statement
The MTP9900 LAA device complies with the FCC RF exposure limits set forth for an
uncontrolled environment and is for intended operation as described in this manual. The further
RF exposure reduction can be achieved if the product can be kept as far as possible from the user
body or set the device to lower output power if such function is available.
This device is intended only for OEM/ODM under the following conditions:
■ The antenna must be installed such that 20 cm is maintained between the antenna and users.
■ The device may not be co-located with any other transmitter or antenna except in accordance
with FCC multi-transmitter guidance.
■ Only antennas approved for use with the MTP9900 LAA may be used.
4.4 Notes about user manual
The OEM/ODM integrator must NOT provide information to the end user regarding how to
install or remove the devices’ RF card in the user manual or any other form of documentation of
another end product based on this MTP9900 LAA device. Any version of user manual based on
this user manual shall include all required regulatory information and warnings.