User's Manual

80-P7567-4 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 12
4 Regulatory Information
4.1 Federal Communication Commission Interference
Statement
This MTP900 LAA device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one of the following
measures:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment and receiver.
■ Connect the equipment into an outlet on a circuit different from which the device receiving
interference is connected.
■ Consult the dealer or an experienced radio/TV technician for help.
This transmitter must NOT be co-located or operated in conjunction with any other antenna or
transmitter.
4.2 Max EIRP compliance for indoor & outdoor deployments
■ Indoor deployment use case: For indoor deployment of the LAA small cell MTP9900 LAA,
an omni-directional antenna with a maximum of 6 dBi antenna gain will be used. This
ensures compliance as per FCC max. EIRP limit of 36 dBm for indoor systems.
■ Outdoor deployment use case: For outdoor deployment of the LAA small cell MTP9900
LAA, an omni-directional antenna system will not be used. In addition to the max EIRP limit
of 36dBm, the outdoor use case antenna system will consist of means to keep the max. EIRP
at elevation angles > 30 degrees from horizon, to be less than 21 dBm. This will be achieved
by using an antenna with the gain characteristics equivalent to the directional patch antenna