Front View Signal LED Battery LED Assistance Button Charging Jack Rear View [image pending]
HERO kit The AmberWatch Mobile HERO kit includes: HERO Device AC Power Adapter : Serial Cable (placeholder) Carrying Case (placeholder) Wrist Strap Quick Start Guide (placeholder)
Other details and use cases still to be included in User Guide: - Thorough table of contents - device is powered “on” after charging - low battery alert - what happens on assistance button press - what happens on assistance button error cases - waterproofing information - web functionality: o web screen shot o Locating o Scheduled check o WAP details -
Powering Up / Down Before first time usage, connect the device to the AC power adapter for at least 12 hours for full battery charging. Powering Up To turn ON the device: Press the On | Off button for three seconds. The Battery and Signal Strength LEDs will blink in the following color sequence: red Æ orange Æ green Powering Down To turn OFF the device, perform the following steps: Press the On | Off button for three seconds.
Status Operation When the device is ON, the Status Pushbutton battery and cellular service indications. provides Press the On | Off button momentarily.
Assistance Operation In order to activate the Assistance mode Press the Assistance button for three seconds. The Battery and Signal Strength LEDs will blink in orange until the initial assistance request is sent. The Battery and Signal Strength LEDs will blink in green until position is determined And sent with assistance request. The Battery and Signal Strength LEDs will remain on in continuous green for 10 seconds.
