User's Manual
Table Of Contents
- Slide Number 1
- Table of Contents
- Introduction
- Getting Started
- Insert Module
- Cable Connections
- Cable Connections
- Power Supply Connections
- Power Supply Connections - Alt
- Module Power Up
- Telephone & Data Call Testing
- Standards
- Regulatory Compliance
- Regulatory Compliance
- Regulatory Compliance
- Internet of Everything Module (IEM) Installation and Collocation Guidelines
- Slide Number 17
- Module Installation Guidelines
- Slide Number 19
- Slide Number 20
- Slide Number 21
- Slide Number 22
Portable Hosts (WWAN to user separation distance <20cm)
The IEM6085 can only be installed in portable hosts under a
Class II Permissive Change, in accordance with KDB Publication
447498, or under a new FCC certification.
End User Installation
End user installation into a product with pre-installed
antennas is prohibited per KDB Publication 996369 D01
††
unless a two-way authentication scheme is enabled to ensure
that only approved module/host combinations can be used together. A
supporting Class II permissive change with appropriate documentation
is also required to support this end user installation option and to
document the authentication scheme.
Simultaneous RF Exposure Evaluation Guidelines For Collocated Transmitters
Allowable through a
Class I Permissive change (Mobile/Fixed Hosts only)
This section defines conditions in which the IEM6085 may be integrated into a host
with simultaneously transmitting antennas without further test, pursuant to KDB
447498, 8)a)ii).
•
††
KDB 996369 is Transmitter Module Equipment Authorization Guide
20