User's Manual
Table Of Contents
- Slide Number 1
- Table of Contents
- Introduction
- Getting Started
- Insert Module
- Cable Connections
- Cable Connections
- Power Supply Connections
- Power Supply Connections - Alt
- Module Power Up
- Telephone & Data Call Testing
- Standards
- Regulatory Compliance
- Regulatory Compliance
- Regulatory Compliance
- Internet of Everything Module (IEM) Installation and Collocation Guidelines
- Slide Number 17
- Module Installation Guidelines
- Slide Number 19
- Slide Number 20
- Slide Number 21
- Slide Number 22
Module Installation Guidelines
This section defines host installation limitations for mobile hosts.
Supporting RF exposure information is located in Section 3.
Host Installation Guidelines
Label Requirements
The FCC and Industry Canada IDs must be permanently affixed on the
exterior of the host device or readily accessible under a panel or battery pack of
the host device that cannot be separated from the host device itself.
Fixed-mount and Mobile Hosts (WWAN to user separation distance ≥20cm)
The IEM6085 can be installed for use in any authenticated fixed-mount or mobile
host device. The maximum WWAN conducted power and antenna gain is listed in
Table 1. Any antenna type is acceptable for use as long as the conditions for peak
gain are met. The integrator must consult with the module OEM and/or the FCC
for equipment or application in which the 20 cm antenna-to-user separation
distance is unclear (see CFR 47 §2.1091(d)(4)).
18