User's Manual
Table Of Contents
- Slide Number 1
- Table of Contents
- Introduction
- Getting Started
- Insert Module
- Cable Connections
- Cable Connections
- Power Supply Connections
- Power Supply Connections - Alt
- Module Power Up
- Telephone & Data Call Testing
- Standards
- Regulatory Compliance
- Regulatory Compliance
- Regulatory Compliance
- Internet of Everything Module (IEM) Installation and Collocation Guidelines
- Slide Number 17
- Module Installation Guidelines
- Slide Number 19
- Slide Number 20
- Slide Number 21
- Slide Number 22
17
For equipment in which the RF exposure classification is unclear (see CFR 47
§2.1091(d)(4)), consult with the module OEM and/or the FCC for
guidance.
4) Allow end-user installation provided module/device Two-Way
Authentication has been addressed so that modules can only be
activated in approved hosts.
The IEM6085 is not intended for installation into
notebook computers as described in KDB Publication
616217
**
and associated supplemental procedures.
Any collocated transmitter or antenna that does not meet
the technical requirements defined in this document
requires a Class II permissive change to authorize
simultaneous transmission.
•
**
KDB 616217 is the FCC procedure SAR Evaluation Considerations for Laptop Computers with Antennas Built-in on Display
Screens.