User's Manual

80-JA863-1 Rev. A 20 QUALCOMM Confidential and Proprietary
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
FENWAY-2 Global User Guide for UMTS/GSM Standards and Regulatory Compliance
– EN 301 511 – GSM900/GSM1800
– EN 301 607-1 – GSM900/GSM1800
– EN 300 328 - WLAN & BT
 CTIA/GCF/PTCRB
 Safety
 EN 50360/61 full carrier certification (carriers TBD)
 RoHS compliance
5.2 Regulatory information
5.2.1 Safety warnings
Do not operate the FENWAY-2 module in the following environments:
 In active blasting areas
 In potentially explosive environments such as refuelling points, fuel depots, or
chemical plants
 Near medical equipment, especially life support equipment that might be susceptible
to radio interference
 In an aircraft as follows:
 FENWAY-2 module transmissions could interfere with aircraft electrical and
communication systems. Like cell phones, using the FENWAY-2 module in an
aircraft is illegal in some jurisdictions.
 If cell phone usage is permitted while the aircraft is on the ground, normal
FENWAY-2 module operation is permitted as well.
5.2.2 North American compliance
The FENWAY-2 module has been authorized for mobile operation in North America. The
initial authorization grant does not permit end-user installation.
For mobile applications, the following conditions must be met:
1. Maintain at least a 20 cm separation between the antenna and the user’s body.
2. Radiated transmit power must be equal to or lower than that specified in the FCC
Grant of Equipment Authorization for FCC ID: J9CUFENWAY-1.
3. To comply with FCC/IC regulations limiting both maximum RF output power and
human exposure to RF radiation, maximum antenna gain (including cable loss) must
not exceed:
 Cellular band < 0 dBi
 AWS band < 0 dBi