User's Manual
Table Of Contents
- 1 Introduction
- 2 Requirements and Setup
- 2.1 Requirements
- 2.2 AP and client setup
- 2.3 DFS test setup configuration
- 2.4 Configuring the AP for DFS tests - Examples
- 2.5 Avoiding false detection
- 2.6 Summary DFS related commands
Requirements and Setup
80-VT830-1 C 11 Qualcomm Confidential and Proprietary
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
2.2.2 Client (slave) setup 1
1. Confirm that the Qualcomm Master Device is configured and running. 2
2. Insert the Linksys USB600N client to any USB 2.0 interface of LP1. 3
3. Confirm that the Linksys WUSB600N client has automatically associated with the 4
Qualcomm Master device. 5
NOTE: The Qualcomm Master device (DUT) has the default network name (SSID) of 6
QUALCOMM_FCC. 7
The association of Linksys WUSB600N client to Qualcomm Master Device can be confirmed by 8
issuing the following command to Qualcomm Master Device through Tera Term Pro console on 9
LP2: 10
Command: aniSdkTool -g sta 11
Output: MAC address of the associated client device 12
--- Station parameters --- 13
ifIndex: 8 14
MAC: 00:1c:10:eb:00:cb 15
16
Total: 1 17
18
19
LP1: IBM T43 20
21
22
Figure 2-3 Client setup 23
2.3 DFS test setup configuration 24
25
1. Follow the steps below to confirm the WCN1320 test setup is ready to use: 26
27