User's Manual

Requirements and Setup
80-VT830-1 Rev. A 11 Qualcomm Confidential and Proprietary
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
During DFS testing it might be required to utilize the same radar affected channel in spite 1
detected radar. Radar channel persistence can be disabled using the following commands: 2
3
Disable persisting radar channel, use the following commands: 4
aniSdkTool –s dfs 0 7 0 5
aniSdkTool –s cga 6
Enable persisting radar channel, use the following commands: 7
aniSdkTool –s dfs 0 7 1 8
aniSdkTool –s cga 9
2.3.8 Deleting the history file 10
To decrease testing time, the radar detection history file on the Qualcomm Master device may be 11
deleted so that channels where radar was detected previously, may be reused. 12
To delete the radar hisfile on the Qualcomm Master, use the following commands: 13
rm /config/wsmSavedRadarDetectList 14
reboot 15
2.4 Configuring the AP for DFS tests - Examples 16
This section describes the steps required to configure the AP for each of the FCC DFS tests. 17
2.4.1 Radar probability test 18
Commands to configure the radar probability test in channel 120 (20MHz): 19
aniSdkTool –s bond 0 0 20
aniSdkTool –s dfs 0 2 120 21
aniSdkTool –s dfs 0 8 1 22
aniSdkTool –s cga 23
24
After the AP is fully booted with the new settings, issue the following command to put AP into 25
probability test mode: 26
dump 19 1 27
2.4.2 Channel move time test 28
Commands to configure the AP for testing channel move time: 29
aniSdkTool –s dfs 0 2 120 30
aniSdkTool –s dfs 0 8 1 31
aniSdkTool –s cga 32
33
After AP is fully booted with new settings, issue the following command to insure that the AP is 34
not in probability test mode. 35
dump 19 0 36