User's Manual
Table Of Contents
- Product Description
- Chipset
- Key Features and Benefits
- Additional Hardware Features
- Data Rates Supported
- Modulation Types Supported
- Security Features
- Quality of Service (QoS) and Value-Added MAC Features
- Antenna Connections
- Manufacturing-Ready Software
- Interfaces
- Physical
- Operating Voltage
- Recommended Operating Temperature Range
- Recommended Operating Humidity Range
- Recommended Storage Temperature Range
- Recommended Storage Humidity Range
- Peak Power Consumption
- Typical Receiver Sensitivity
- Operating Frequencies/Bands
- Maximum Transmit Output Power
- Physical Dimensions
- Modular Installation
- 65-VF320-P2 Antenna Specifications
- Product Labeling
- Product Usage
- Product Documentation
65-VF320-P2
WLAN MiniPCI a/b/g/n Adapter
Product Specification and Modular Installation
Rev 0.2 • http://www.cdmatech.com/products/wlan.jsp • Page 4 of 21
Qualcomm Confidential Information Document # MA423D_H_PS_V2
Product Description
QUALCOMM’s 65-VF320-P2 MiniPCI Adapter design is based on QUALCOMM’s advanced multi-radio
WFB4030 Baseband/MAC IC and WFR4031 RF IC, and IEEE 802.11a/b/g/n wireless LAN solution that
sends and receives data at up to 300 Mbps. Using QUALCOMM’s advanced chipset with patented True
MIMO™ smart antenna technology, QUALCOMM WFB400-based products provide unprecedented
levels of 802.11a/b/g/n range and throughput, previously unachievable speed and spectral-efficiency, full
Wi-Fi product interoperability for IEEE 802.11a/b/g/n, and IEEE 802.11b/g/n global regulatory
compliance.
Chipset
• WFB4030 and WFB4130 Single Chip integrated Baseband and MAC
• WFR4031 Single Chip 2.4/5 GHz 2Tx/3Rx transceiver
Key Features and Benefits
The fourth generation, QUALCOMM’s IEEE 802.11n True MIMO
TM
chipset, provides the implementer of
access points, home gateways, WLAN clients, consumer electronics and multimedia entertainment,
embedded wireless laptop/desktop/peripheral products with the following key features:
• IEEE 802.11n, IEEE 802.11a, IEEE 802.11b, IEEE 802.11g Network Standards
• MIMO link rates up to 300 Mbps
• 2.4/5 GHz Frequency Band Operation
• Receive Combining and Transmit Diversity
• Dynamically adjusts between 20 and 40 MHz
1
operation on a frame by frame basis
• Interoperability with IEEE 802.11b/g/n , and pre-standard 802.11n Draft 1.0 and 2.0 products
• IEEE 802.11d support
• IEEE 802.11b Long / Short Preamble support on a frame-by-frame basis
• Transmit rate based power control
Additional Hardware Features
• Enhanced interference avoidance
1
40 MHz mode at frequencies requiring DFS (Dynamic Frequency Selection) is governed by regulatory
certification. For FCC certification, the 5.25-5.35GHz and 5.47-5.725GHz Frequnecy Bands are dissabled
by software.