User's Manual
Table Of Contents
- Product Description
- Chipset
- Key Features and Benefits
- Additional Hardware Features
- Data Rates Supported
- Modulation Types Supported
- Security Features
- Quality of Service (QoS) and Value-Added MAC Features
- Antenna Connections
- Manufacturing-Ready Software
- Interfaces
- Physical
- Operating Voltage
- Recommended Operating Temperature Range
- Recommended Operating Humidity Range
- Recommended Storage Temperature Range
- Recommended Storage Humidity Range
- Peak Power Consumption
- Typical Receiver Sensitivity
- Operating Frequencies/Bands
- Maximum Transmit Output Power
- Physical Dimensions
- Modular Installation
- 65-VE240-P1 Antenna Specifications
- Product Labeling
- Product Usage
- Product Documentation
65-VE240-P1
802.11b/g/n MiniPCI Adapter for 2.4 GHz AP Applications
Product Specification and Modular Installation
Rev 0.2 • http://www.cdmatech.com/products/wlan.jsp
• Page 16 of 16
Qualcomm Confidential Information Document # 640-00134-01
Product Documentation
Following RF exposure information shall be supplied in end-users manual for products containing the 65-
VE240-P1:
IMPORTANT NOTE:
To comply with FCC RF exposure compliance requirements, the antennas
used for this transmitter must be installed to provide a separation distance of
at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.