User's Manual
Table Of Contents
- Product Description
- Chipset
- Key Features and Benefits
- Additional Hardware Features
- Data Rates Supported
- Modulation Types Supported
- Security Features
- Quality of Service (QoS) and Value-Added MAC Features
- Antenna Connections
- Manufacturing-Ready Software
- Interfaces
- Physical
- Operating Voltage
- Recommended Operating Temperature Range
- Recommended Operating Humidity Range
- Recommended Storage Temperature Range
- Recommended Storage Humidity Range
- Peak Power Consumption
- Typical Receiver Sensitivity
- Operating Frequencies/Bands
- Maximum Transmit Output Power
- Physical Dimensions
- Modular Installation
- 65-VE240-P1 Antenna Specifications
- Product Labeling
- Product Usage
- Product Documentation
65-VE240-P1
802.11b/g/n MiniPCI Adapter for 2.4 GHz AP Applications
Product Specification and Modular Installation
Rev 0.2 • http://www.cdmatech.com/products/wlan.jsp • Page 15 of 16
Qualcomm Confidential Information Document # 640-00134-01
• Frequency Range: 2.4 to 2.5 GHz
• Impedance: 50 Ohms nominal
• VSWR: 2.0
• Normal Gain: 2 dBi @ 2.45 GHz
• Radiation: Omni-directional
• Polarization: Vertical
Product Labeling
The 65-VE240-P1 radio transmitter module is authorized only for use in a device where the antenna may be
installed such that 20 cm can be maintained between the antenna and the users. End-user products
containing 65-VE240-P1 modules
MUST have affixed to their labels the following phrase:
This product contains FCC ID: J9C-65VE240P1 module
Product Usage
This device is intended only for OEM/ODM integrators under the following conditions:
1. The antenna must be installed such that 20 cm is maintained between the antenna and users.
2. The transmitter module may not be co-located with any other transmitter or antenna.
3. Use only authorized antenna(s) as described in the FCC filing under FCCID: J9C-65VE240P1
The OEM/ODM integrator is responsible for testing their product for any additional compliance mandates
required when this module is installed within an end-user product.
i IMPORTANT NOTE: In the event that these conditions cannot be met,
then the FCC authorization is no longer considered valid and the FCC ID
number cannot be used on the final product and thus the OEM/ODM
integrator will be responsible for re-evaluating the end product (including
the transmitter) and obtaining a separate FCC authorization.
You are cautioned that changes or modifications not expressly approved by the party responsible
for compliance could void your authority to operate the equipment.