User's Manual
6
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 80-KA125-1 Rev. A
Qualcomm Labs, Inc. and Qualcomm Incorporated Condential and Proprietary
80-KA125-1 Rev. A
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
7
Qualcomm Labs, Inc. and Qualcomm Incorporated Condential and Proprietary
Table 2-3 Short-range radio communication status
Symbol color Short-range radio communication status
Solid GREEN
Your medical device has successfully paired with the 2net Hub.
Solid YELLOW 2net Hub is starting. After successful start-up, the solid
YELLOW light means the 2net Hub is ready to pair with
medical device.
Solid RED 2net Hub needs to be reset. It will automatically start this
reset process. No user intervention is needed.
Flashing GREEN 2net Hub is collecting data from your medical device.
Flashing YELLOW 2net Hub start up is in progress.
Flashing RED 2net Hub is unable to pair with your medical device.
(about 10 times Tip: Try pairing the 2net Hub and device again. Follow the
a second) easy 3-step process in the section “Making the 2net Hub
work with your medical device(s)” below. If the light is still
ashing RED, please contact your medical device company’s
customer support.
No color No AC power is being supplied to the 2net Hub.
3. Using your 2net Hub
3.1 Plugging in the 2net Hub
To start using your 2net Hub, rst plug it into a
standard electrical wall outlet in the same room
as the medical device(s) you want to use it with.
When you plug the 2net Hub in, you will see the
two lighted symbols below turn solid YELLOW.
After a few seconds, both symbols will start
ashing YELLOW; they will continue ashing
for up to 5 minutes. Then you should see the
symbol with the bars turn solid GREEN.
When this happens, the symbol with the house will turn solid YELLOW,
indicating that the Hub is ready to “pair” with (communicate with) your medical
device that was purchased with your 2net Hub.
If the bars symbol does not turn solid GREEN or does not stay that way, the 2net
Hub is not receiving a strong enough signal from the cellular network. Please
refer to Chapter 4, Troubleshooting tips.
If the house symbol ever turns solid RED, the 2net Hub needs to be reset. It will
automatically start this reset process. No user intervention is needed.